| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Foundry Technology Forum > Message
Main Menu

[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: RT vs. UT correlation of casting defects

Date: 06/30/01 at 8:51 PM
Posted by: piyush
E-mail: piyush_a@hotmail.com
Message Posted:

In Reply to: RT vs. UT correlation of casting defects posted by Dave Carr on 03/08/01 at 6:35 AM:

i have not seen a published literature on this subject
though it seems a very obvious requirement. i did some
work to correlate in a specific casting E186 and
using drilled hole specimens for ut calliberation .
i could pretty well use UT as a go no go gage
for level three RT (E186)

Follow Ups:

Post a Follow-up:


Message to Post:


1999-2001 Sunlit Technology Co., Ltd. All rights reserved.