| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Printed Circuit Designers' Forum > Message
Main Menu
Glossary of Printed Circuit Design and Manufacturing

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: How I can generate drill file?

Date: 03/04/03 at 2:52 PM
Posted by: skip
E-mail: skip.yutkus@apw.com
Message Posted:

In Reply to: How I can generate drill file? posted by Arisara K. on 03/04/03 at 2:21 AM:

Create a gerber layer with the pads the same sizes as the drills you want then go to the NC-Editor and use - Gerber-Drill tool and it will create an NC file and drill table - you may then edit the table for plated, unplated etc.Skip

Follow Ups:

Post a Follow-up:


Message to Post:


1999-2001 Sunlit Technology Co., Ltd. All rights reserved.