| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Printed Circuit Designers' Forum > Message
Main Menu
Glossary of Printed Circuit Design and Manufacturing
Find

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: solder mask to mark brass base?

Date: 10/17/03 at 9:38 AM
Posted by: Gary Provencher
E-mail: gary@leddynamics.com
Message Posted:

I have a brass base, of a candelabra for example, that I want to hard-mark with my company logo. It was, by a coworker, suggested that I use a solder mask cut out a relief of our logo, flux it and dip it in a solder pot, and then remove the solder mask to reveal our logo hard marked on the base. Is this reasonable, or is he blowing smoke up my backside? I know that I could just have the logo laser etched into the base, but we already have the solder pot and other items in-house. The point is that I need a permanent electrically conductive logo, and to do so in house and inexpensively.

Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.