| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Printed Circuit Designers' Forum > Message
Main Menu
Glossary of Printed Circuit Design and Manufacturing
Find

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: blind and buried in protell99se

Date: 09/22/03 at 3:39 PM
Posted by: Rick J
E-mail: rjoike@tds.net
Message Posted:

In Reply to: blind and buried in protell99se posted by K.Vivek on 09/22/03 at 2:06 PM:

From the Placement Toolbar select the add via icon, while the via is attached to the cross hairs press the TAB key. This brings up the via properties pop-up, here you can select the staring and ending layer as well as the pad and hole sizes. Hope this helps.


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.