| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Printed Circuit Designers' Forum > Message
Main Menu
Glossary of Printed Circuit Design and Manufacturing
Find

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Power Supply Filter Board

Date: 09/17/03 at 1:57 PM
Posted by: Bill Smith
E-mail: ko4nrbs@yahoo.com
Message Posted:

My need is for a very simple power supply filter
board. It has eight snap-in type electrolytic
capacitors on it wired in series(+ to -). In addition
each
capacitor has two 100k ohm 3 watt resistors connected
in parallel. The boards dimensions are 6" by
6". The pin spacing for the capacitors is 10.5mm and
the holes for the pins are 2mm in diameter. The
diameter of the capacitors is 35.56mm and they are
50.8mm tall. As long as the capacitors are connected in series it doesn't matter where they are located on the board.

Can someone produce a layout for me so I can have someone make me a board?

Thanks,
Bill


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.