| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Printed Circuit Designers' Forum > Message
Main Menu
Glossary of Printed Circuit Design and Manufacturing
Find

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: Tango PCB on Windows 2000

Date: 09/03/03 at 12:11 AM
Posted by: Evan Scarborough
E-mail: evan027@juno.com
Message Posted:

In Reply to: Re: Tango PCB on Windows 2000 posted by Pat Johnson on 08/19/03 at 7:59 AM:

So far I have the same problem and as one responder said; basically get an old system to run it native in DOS, and that's the best way, but if you can get windows 98 to run on your system (as a dual boot with System Commander or similar) it's then only a matter of setting up the path and memory assignments in the "PIF" that windows uses - I have Tango running great full screen only and it even uses the VESA drivers for good resolution and it used to run under win NT 4.0 (& it's the same hardware that win2k uses now refuses to run it so I believe that it's not a hardware problem as windows troubleshooter seems to indicate) - that's progress! (I'm not a regular follower of this BBS, but e-mail me off line if you want to follow up and then re-post my response so it gets shared here)
Good Luck!


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.