| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Printed Circuit Designers' Forum > Message
Main Menu
Glossary of Printed Circuit Design and Manufacturing

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Protel 99SE - Polygon plane - feed in Trace size

Date: 08/01/03 at 3:05 PM
Posted by: mindy
E-mail: mindy1701@hotmail.com
Message Posted:

Hi all

Im trying to laydown polygon plane fills over a hi current section.

But every time I place them they only connect to the
pads/vias with a 10mil traces no matter what the trace settings are. The fill will be the correct size and width
but no the connections to the pads.

Does anyone know where this setting is control from ?


Follow Ups:

Post a Follow-up:


Message to Post:


1999-2001 Sunlit Technology Co., Ltd. All rights reserved.