| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Printed Circuit Designers' Forum > Message
Main Menu
Glossary of Printed Circuit Design and Manufacturing
Find

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: EasyPC DOS Setup

Date: 12/16/02 at 4:57 PM
Posted by: Bob Grey
E-mail: bgrey@btinternet.com
Message Posted:

Hi there

Found this site whilst browsing to see if anyone out there can help me with a problem with easyPC.

I bought a copy years ago and just starting to use it on a new project. I had a problem running under Windows 2000 due the characters being garbage (seen others had this too). I got hold of an old PC 486-DX with 7168K extended memory and loaded DOS 6.2 onto this.

Program seemed to work OK however noticed that when I create a layout and save it, if I restart EasyPC and try to load the file I get a file is not a valid EasyPC file. However if I load one of my old layouts (a big one) it loads OK. Sometimes I get a memory full error.

My problem is that I've forgotten a lot of the old DOS Autoexec and Config.sys commands - I suspect my problem is something to do with memory. Anyone out these have any ideas as to how to sort this please?

Thanks

Bob


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.