| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Printed Circuit Designers' Forum > Message
Main Menu
Glossary of Printed Circuit Design and Manufacturing
Find

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: Impedance Control

Date: 07/17/03 at 3:50 AM
Posted by: trilok
E-mail: trilok71@yahoo.com
Message Posted:

In Reply to: Re: Impedance Control posted by ashok pataudi on 07/16/03 at 7:02 PM:

In multilayer board design usually we consider 50 ohm impedence & use trace width of 5 mil or 4 mils
depending upon requirement.
There are several ways of achieving impedence control,the most prefered is by varying the prepeg (dielectric material)in PCB.
You have to specify details to PCB Vendors.


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.