| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Printed Circuit Designers' Forum > Message
Main Menu
Glossary of Printed Circuit Design and Manufacturing

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: PCB design software; which is the best???

Date: 07/03/03 at 5:05 AM
Posted by: Ritesh Patel
E-mail: ritesh@z6.com
Message Posted:

In Reply to: Re: PCB design software; which is the best??? posted by Karthik PVS on 07/01/03 at 12:55 PM:

We've worked on Cadstar, PADS, Mentor Board station, i feel if you take cost to performance trade off Cadstar is the best.

You can do most complex layout in it, and also it is having 3D modeling module also, now Cadstar SI plus is also available, it uses incases engine for doing the analysis. Cadstar has full flow from schematic capture till high speed analysis.

If cost is not the constraint them cadence or mentor is good.


Follow Ups:

Post a Follow-up:


Message to Post:


1999-2001 Sunlit Technology Co., Ltd. All rights reserved.