| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Printed Circuit Designers' Forum > Message
Main Menu
Glossary of Printed Circuit Design and Manufacturing
Find

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: Two-layer or 4 layer? / Ground plane?

Date: 05/15/03 at 11:24 AM
Posted by: Jeffrey Myint
E-mail: jeffm@cadcom.com
Message Posted:

In Reply to: Two-layer or 4 layer? / Ground plane? posted by Jeffrey Myint on 05/15/03 at 11:18 AM:

Well the editor sure butchered my nice drawing.Perhaps verbally will work better.16 talk paths consisting of a head set inline with a 270ohm resistor, followed by a 22uf capacitior, followed by another 270 ohm resitor, coneect to the MTP16 analog connection. The other end of the MTP16 analog connection is tied to the other end of the headset load. The 22uf cap has a 48 volt supply across supplying power to the circuit.Hope this is a little better


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.