| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Printed Circuit Designers' Forum > Message
Main Menu
Glossary of Printed Circuit Design and Manufacturing
Find

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Two-layer or 4 layer? / Ground plane?

Date: 05/15/03 at 11:18 AM
Posted by: Jeffrey Myint
E-mail: jeffm@cadcom.com
Message Posted:

My company has been using a two sided board for analog telephony. Talk paths from a Music Telecom MPT16 provide analog voice from one end of the board while a headset with mic provide analog voice into the other end of the PCB board.

The PCB board consists of 16 talk paths that are electrically as shown below

pwr supply
- 48v +
| |
*-----|resistor|---*--||--*---|resistor|-----*
| 270 ohms 22uf 270 ohms |
Head MTP16
Set (600 ohm)
| |
*--------------------------------------------*

Problem: This design has a huge amount of crosstalk. Conversations can be heard and held between the different circuits.

I am not an analog hardware or PCB designer. I'm just the manager who needs to come up with a coss-talk free solution. Do we need ground planes ? Shielding? A different ciruit design?

Any suggestions would be welcomed.



Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.