| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Printed Circuit Designers' Forum > Message
Main Menu
Glossary of Printed Circuit Design and Manufacturing

[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: Importing Gerber files into Protel

Date: 09/19/00 at 11:27 PM
Posted by: Abelardo Elizondo
E-mail: general@intelectro.com
Message Posted:

In Reply to: Importing Gerber files into Protel posted by B.S. on 07/20/00 at 9:20 AM:

It sounds like the problem may be that the gerber graphics are imported at a scale that's too large for the work area defined in protel or that the zero of the graphics make them fall out of the protel work area.

Follow Ups:

Post a Follow-up:


Message to Post:


1999-2001 Sunlit Technology Co., Ltd. All rights reserved.