[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Date: 07/14/03 at 10:02 AM
Posted by: Daniel Moyano
E-mail: damoyano@ciec.com.ar

In Reply to: Re: tutorial for orcad ver. 9? posted by tayron on 03/19/02 at 1:49 PM:

I am working whith Orcad 9 layout and I have the follow problem:
The board is a single side and I need the autorouter draw all jumpers it was necesary to complete the conections. I have seted TOP LAYER as JUMPER LAYER TYPE, I have choosed LENGTH JUMPER and FOOTPRINTS. The via cost is set in 40. But after autorouter run, some conections didn't complete and no any jumper apear in the draw. I can understand the reason because the auto router don't define the necesarie jumper automatically. Pleas, I will thank you if sombody could help me.

Daniel

Follow Ups:

Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post: