| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Printed Circuit Designers' Forum > Message
Main Menu
Glossary of Printed Circuit Design and Manufacturing

[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: Looking for CAM350 users

Date: 08/16/02 at 11:26 PM
Posted by: JBWilliams
E-mail: midnight_blue_designs@yahoo.com
Message Posted:

In Reply to: Looking for CAM350 users posted by John on 01/31/01 at 8:19 PM:

I've been using CAM350 for several years now, although I haven't gotten into writing any macros.

CAM350 is now run under DOWNSTREAM Technologies, since PADS (INNOVEDA) got tired of owning them.


I'm not immediately aware of any User's Group or forum on CAM350, that's not to say there aren't any.


Follow Ups:

Post a Follow-up:


Message to Post:


1999-2001 Sunlit Technology Co., Ltd. All rights reserved.