| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Printed Circuit Designers' Forum > Message
Main Menu
Glossary of Printed Circuit Design and Manufacturing

[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: Protel99se PCB design-Polygon Place problems

Date: 06/05/01 at 9:40 AM
Posted by: S. Leprohon
E-mail: sleprohon@str.qc.ca
Message Posted:

In Reply to: Protel99se PCB design-Polygon Place problems posted by B.S. on 07/18/00 at 10:38 AM:

Hi B.

I used Protel99se enough to think that your traces corners are not on grid. If you do not make trace corners of 90 deg, 45 deg, 135 deg or perfect circles, you will have some problems, you should check this out!

Follow Ups:

Post a Follow-up:


Message to Post:


1999-2001 Sunlit Technology Co., Ltd. All rights reserved.