| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Printed Circuit Designers' Forum > Message
Main Menu
Glossary of Printed Circuit Design and Manufacturing
Find

[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: EZRoute software users

Date: 03/20/01 at 4:10 PM
Posted by: Bill Jenkins
E-mail: bjenkins@direct.ca
Message Posted:

In Reply to: Re: EZRoute software users posted by Joe Utasi on 03/16/01 at 3:22 PM:

The latest EZ-Route2000 demo disk is available.
1: Pans on bump when extending a line or pad, but bumping with the cursor will not work unless you use cursor arrows.
2: still 25 pads in table, but work is being done on a 200 pad table, rotatable pads again.
3: rounded ends on lines

4: automatic RS274X gerbers and a new gerber viewer. Data is embedded, display shows red (flashed) and blue (drawn)
5: as above in 4
6: will be finished when the pad table is updated.

All programs are available at all times, no need to go to dos like doing gerbers before. Go to File and select: board, schematic, gerber editor, symbol editor ( display screen is interactive making it easier to modify your symbols). Work in schematic, do your .upd file, work in board, select from window and enter schematic. Run multiple screens.
This covers most of your questions and EZRoute2000 is now handled by a different supplier. I used and sold versions since 1987 and now I'm the only supplier. Email support within 24 hours, (note this time I have been having computer problems, but am now up again).

I can email a quick slide show 800Kb so you can see the steps and actual screen shots.

I also provide prototypes, s/s, d/s, pth, silk, soldermask, etc

Previous users can update for a special price.
Thanks
Bill


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.