| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Printed Circuit Designers' Forum > Message
Main Menu
Glossary of Printed Circuit Design and Manufacturing
Find

[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: Acute angles

Date: 02/05/01 at 3:25 AM
Posted by: jeff zhu
E-mail: jeff_zhu@hotmail.com
Message Posted:

In Reply to: Acute angles posted by Danny Baker on 12/06/00 at 1:35 PM:

In high frequency signal route, acute angle is not permitted since the parasitic inductor would be large and influence the high freq impedence.In Taiwan made board, people even don't like 90 degrees track. But in US board i can easily find this routing.Be sure that acute angle is not a good idea in pcb routing


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.