| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Printed Circuit Designers' Forum > Message
Main Menu
Glossary of Printed Circuit Design and Manufacturing

[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: PADS vs Protel

Date: 02/03/01 at 7:06 AM
Posted by: Jeff Zhu
E-mail: jeff_zhu@hotmail.com
Message Posted:

In Reply to: PADS vs Protel posted by Eric Zeno on 02/01/01 at 12:29 PM:

PADS2000 for DOS is the best PCB design tools for large scale digital board because of it's flexible manual route. I once use it for PC motherboard manual routing at MSI. But only SiS6326 AGP card can be used for this software.

If you are designing mediam or small system, protel is ok, but not suitable for large board.

Follow Ups:

Post a Follow-up:


Message to Post:


1999-2001 Sunlit Technology Co., Ltd. All rights reserved.