| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Analog Circuit Design Forum > Message
Main Menu
Find

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: Designing current source?

Date: 10/26/03 at 9:14 PM
Posted by: Jem
E-mail: Jemidar[AT55]hotmail.com (replace [AT55] with @ to reply)
Message Posted:

In Reply to: Re: Designing current source? posted by Russ Kincaid on 10/26/03 at 5:19 PM:

You can also try Micrel (MIC4576BT), or Linear Tech (LT1074). Both are very simple buck regulators, and have built-in pass transistor. I have used the Lt part, and it is quite stable. I assume the Micrel part would do just as fine. You set the OP voltage buy using a couple of 1% resistors.


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.