| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Analog Circuit Design Forum > Message
Main Menu
Find

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: Analog vs Digital

Date: 07/30/03 at 10:18 AM
Posted by: Russ Kincaid
E-mail: russ-nospam[AT55]engineer.com (replace [AT55] with @ to reply)
Message Posted:

In Reply to: Analog vs Digital posted by Sarkuna on 07/30/03 at 4:10 AM:

When laying out an analog board, keep inputs and outputs seperated. Be aware of capacitive effects on high impedance lines. You should know what a guard ring is, and how to use it. Ground runs should go to a common point as far as possible to avoid cross-coupling. Be aware of special requirements of ICs, look up the data sheets.

Digital layout is less fussy if the speed is low, but still pay attention to ground runs and use plenty of power line bypassing. Speeds above 100 mHz should use transmission line techniques.


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.