| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Analog Circuit Design Forum > Message
Main Menu
Find

[ List Subjects ][ Main Page ]
[ View Followups ][ Post Followup ]

Subject: Re: using UCN5804B chip to control stepper from parallel port problem

Date: 08/04/03 at 3:21 PM
Posted by: charles
E-mail: snafubike16@email.com
Message Posted:

In Reply to: using UCN5804B chip to control stepper from parallel port problem posted by robert harpham on 04/25/03 at 10:33 AM:

i have been having the same problem. the output is to fast for the stepper motor to keep up. my input step has been picking up the 60 hz ac current in my house and using it as a signal. i would say try using a 555 timing chip or some sort of timing device to slow down the stepping procedure. it might work


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.