| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Analog Circuit Design Forum > Message
Main Menu
Find

[ List Subjects ][ Main Page ]
[ View Followups ][ Post Followup ]

Subject: Re: changing dc polarity

Date: 03/12/03 at 11:58 PM
Posted by: Russ Kincaid
E-mail: russlk@netzero.com
Message Posted:

In Reply to: changing dc polarity posted by janet on 03/07/03 at 12:54 PM:

Case 1: Look up "H bridge". That is what you need.

Case 2: Use 6 volts to operate a relay to connect the motor to the 9.6 volt battery. If the polarity can reverse, use diodes to steer the voltage to the relay.

case 3: Your low frequency receiver has a selectivity problem.

case4: Put the relay in a diode bridge so it is energized with either polarity.


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.