| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Analog Circuit Design Forum > Message
Main Menu
Find

[ List Subjects ][ Main Page ]
[ View Followups ][ Post Followup ]

Subject: Re: phase linear 700b

Date: 05/14/03 at 5:24 AM
Posted by: Mike PIoso
E-mail: mpioso@bellatlantic.net
Message Posted:

In Reply to: phase linear 700b posted by mike on 03/23/03 at 8:04 PM:

Hi. Yes, it usually means either one or more of the output trannies have gone, but that would also mean that one or both of the fuses have gone, which affects both channels at the same time, i believe. If they are intact, you have a failure on the preamp board and they can be a plain pain in the ass to repair, as the trannies are almost impossible to find. I have been working on a pl 400 II for several weeks! With no load on the channel, there is enough power to run the meters but when loaded, the protection circuit shuts the channel down. Wondering whom you bought it from. Good luck. I have a Service Manual for this unit if you need it - it is currently up on eBay! :)

Mike


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.