| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Analog Circuit Design Forum > Message
Main Menu
Find

[ List Subjects ][ Main Page ]
[ View Followups ][ Post Followup ]

Subject: Re: op-amp design techniques

Date: 11/22/02 at 11:13 AM
Posted by: Russ Kincaid
E-mail: russlk@netzero.com
Message Posted:

In Reply to: op-amp design techniques posted by David on 11/22/02 at 3:02 AM:

You must insure that the voltage at the diff amp input does not exceed the commmon mode range. That usually is done by making the lower end of the voltage divider the same as ground for the diff amp, but could be common to the minus supply (assuming the 100V is positive) and also assuming that the two circuits don't have a common ground anyway.


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.