| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Analog Circuit Design Forum > Message
Main Menu

[ List Subjects ][ Main Page ]
[ View Followups ][ Post Followup ]

Subject: Re: Dunce question

Date: 02/28/03 at 5:21 PM
Posted by: andrew
E-mail: andrewolds@hotmail.com
Message Posted:

In Reply to: Re: Dunce question posted by Brian Snell on 02/28/03 at 10:57 AM:

It will be relatively easy to incorporate the disc onto the end of the spedo cable, as the square tang that engages with the driving gear protrudes out of the gear. a suitable disc could easily be slipped onto the cable end with a spacer. There are also a couple of unused factory bolt holes nearby, these could be used for the sensors.

As for the spedo ratio, will have to get back to you, Its not given in the factory manual, i'll have to measure up the rear wheels and work it out


Follow Ups:

Post a Follow-up:


Message to Post:


1999-2001 Sunlit Technology Co., Ltd. All rights reserved.