| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Analog Circuit Design Forum > Message
Main Menu

[ List Subjects ][ Main Page ]
[ View Followups ][ Post Followup ]

Subject: Re: Need help to implement and design Alarm sensors circuit using microntroller(68HC11) and telephone line

Date: 06/30/02 at 10:25 PM
Posted by: Mohd Ariffanan Mohd Basri
E-mail: anaffira@yahoo.com
Message Posted:

In Reply to: Need help to implement and design Alarm sensors circuit using microntroller and telephon line posted by Khalifa on 02/06/02 at 2:42 AM:

In this project I tried to make the remote access by telephone. The computer (microcontroller 68HC11 )is used to control the interface between user and system. The controller can be accessed close or open an appliances and Check an alarm status. The alarm system composes of Heat Detectors Smoke Detectors and Door Magnetic Switchs. When the alarm system is activated, the controller will dial telephone to the programmed number to inform alarms.
Any help in a part of this project is needed and will appreciated...
with my thanks on advance.
Note: I also need a schematic or A discription of how the phone dialing system. "cause I will inteface the system with the telephone line to send the programmed number from the microcontroller to the phone and then auto dial it "

Follow Ups:

Post a Follow-up:


Message to Post:


1999-2001 Sunlit Technology Co., Ltd. All rights reserved.