| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Analog Circuit Design Forum > Message
Main Menu

[ List Subjects ][ Main Page ]
[ View Followups ][ Post Followup ]

Subject: Re: 9 Volt Split

Date: 03/27/02 at 12:09 PM
Posted by: John Dunn - Consultant
E-mail: ambertec@ieee.org
Message Posted:

In Reply to: 9 Volt Split posted by Garry Kellogg on 03/27/02 at 11:38 AM:

Hi, Gary.

I just e-mailed a suggested circuit to you. It uses a voltage divider to establish the 3V and 6V derivation from your 9V battery and a single op-amp to buffer that split. The op-amp output has to carry the difference current between the 3V section's current and the 6V section's current.

Good luck.

John Dunn - Consultant
Ambertec, Inc.

Follow Ups:

Post a Follow-up:


Message to Post:


1999-2001 Sunlit Technology Co., Ltd. All rights reserved.