| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Analog Circuit Design Forum > Message
Main Menu

[ List Subjects ][ Main Page ]
[ View Followups ][ Post Followup ]

Subject: edgemeter

Date: 10/10/00 at 12:20 PM
Posted by: Michael Ryan
E-mail: mryan@pipehorn.com
Message Posted:

Please help locate a supplier for an edge panel meter.
Panel thickness 1/8 inch
Depth behind panel less than 1.25 inches
The meter will be housed in a half round
Compartment. The radius is 1 inch.
Therefore, the following width x height
Pairs are acceptable.
Width x height
1.25" x .75"
1.5" x .638"
1.75" x .451"
The face of the meter will protrude
At least the thickness of the panel and
No greater than 1/8".

Follow Ups:

Post a Follow-up:


Message to Post:


1999-2001 Sunlit Technology Co., Ltd. All rights reserved.