| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Analog Circuit Design Forum > Message
Main Menu
Find

[ List Subjects ][ Main Page ]
[ View Followups ][ Post Followup ]

Subject: Re: Triac: Why is this used in Geyser?

Date: 02/06/01 at 2:29 PM
Posted by: John Dunn - Consultant
E-mail: ambertec@ieee.org
Message Posted:

In Reply to: Re: Triac: Why is this used in Geyser? posted by Bill on 02/05/01 at 10:53 PM:

Hi, Bill.

It's a worthy caution, but I doubt that burn-out would be likely; the triac would have probably assumed a near 100% conduction time when the geyser was running running at fill tilt.

Still, Gouri, a bit of care may be well advised. "Better safe than sorry" as the adage goes.

Good luck.

John Dunn - President
Ambertec, Inc.
ambertec@ieee.org


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.