| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Analog Circuit Design Forum > Message
Main Menu
Find

[ List Subjects ][ Main Page ]
[ View Followups ][ Post Followup ]

Subject: Re: Triac Insulation vs Isolation

Date: 12/14/00 at 1:04 AM
Posted by: Alan Dorman
E-mail: aldor@coam.net
Message Posted:

In Reply to: Triac Insulation vs Isolation posted by Norman Baccari on 12/12/00 at 8:42 AM:

Use a ohm meter and check the case metal to all three contacts on the triac. Any resistance reading, on the low ohms setting, means that the case is not isolated. If it is not then you will need a ceramic or mica insulator and plastic or nylon spacers so the mounting screws dont short to the case. The triac you are replacing is a Teccor triac and you could probably get a free sample from a company called Omni-Pro in Texas, they are a major Teccor distributor. Call 972-713-9000 and ask for Brenda.


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.