| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Electronics Manufacturing and Automation Forum > Message
Main Menu
Find

[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: Soldering flat flex ribbon cable

Date: 11/20/02 at 6:05 PM
Posted by: Kathy
E-mail: kathy@btw-inc.com
Message Posted:

In Reply to: Re: Soldering flat flex ribbon cable posted by v k srivastav on 10/01/02 at 12:34 PM:

You might want to try a solder splice if you are going to solder and cover the solder joint with heat shrink anyways. Or you can split the ribbon cbale back so all of the wires are loose. Then tin the wires in a small solder fountain using a no-clean or a RMA flux. Do not use water soluble since it will cause long term reliability issues. The solde reach wire on. The solder splice is a slick little idea though adn they come in a range of sizes.


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.