| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Electronics Manufacturing and Automation Forum > Message
Main Menu
Find

[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: Soldering flat flex ribbon cable

Date: 10/11/02 at 8:55 AM
Posted by: Stephen Guarino
E-mail: stephen_guarino@ademco.com
Message Posted:

In Reply to: Soldering flat flex ribbon cable posted by Paul Peterson on 09/11/02 at 7:24 AM:

sounds like you need some hot bar soldering equipment. It is not not that costly but would require high volume to justify its cost. You would due better if you get you flat cable vendor to build a connector on the flat cable


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.