[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Date: 11/27/01 at 3:47 PM
Posted by: Steve
E-mail: steve@plcman.co.uk

In Reply to: Positioning Module problem posted by Halim Souissi on 10/20/01 at 7:42 PM:

Yes you will need the COM 726 Software from Siemens. I would also suggest you get hold of the manual for the WF card and for the software.
The software can be run on the Siemens PG.
It will allow you to configure the WF card as well as setting the machine data; tool offsets; operating data and control configuration.
It can be used online or offline.

hope this helps.

PS If possible can you send me a copy of the parametrisation file S13800ST.126 and the standard FBs

Steve.

Follow Ups:

Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post: