| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > PCB Rework and Repair Forum > Message
Main Menu
Find

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Rework or not Rework?

Date: 09/12/01 at 5:31 AM
Posted by: Jim Truelove
E-mail: jim.truelove@edwards.boc.com
Message Posted:

Can anyone point me to research / discussions on the subject of reworking printed circuit assemblies (PCAs).
There have always been suggestions from experts that touching up solder joint because of blow holes, pin holes etc. causes more hidden damage and latent defects than leaving them alone would.
We are trying to establish a standard, without lowering our already high workmanship standards.
Any comments?

Follow Ups:


Post a Follow-up:

No Follow Ups for this message is needed here. Please use the following link to go back to the current board of this forum. You could create a new thread there if it is needed.

[ Go Back ]

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.