| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Computer Build and Repair Forum > Message
Main Menu
Find

[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: HP Scanjet 5100C Service Manual

Date: 02/28/03 at 9:37 AM
Posted by: Craig A
E-mail: davcrag@aol.com
Message Posted:

In Reply to: HP Scanjet 5100C Service Manual posted by Shaun Crass on 02/28/03 at 9:12 AM:

Try removing the lid and gently running the scanner from end to end (with the power off) with your hand. Do not touch the bulb. See if there is any resistance when you manually move it from end to end. Finally, put the scanner (the section with the bulb) all the way at the bottom of the unit (the section opposite from the area where the lid hinges are). Power it back up and see if it still does it. There isnt much to these units. Its could be a bad sensor but pretty unlikely.

Craig


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.