| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > EMC and Safety Regulatory Expertise Forum > Message
Main Menu

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: EMC on PCBs ???

Date: 08/24/00 at 9:22 AM
Posted by: Clyde Manning
E-mail: clyde_manning@storagetek.com
Message Posted:

In Reply to: Re: EMC on PCBs ??? posted by Jens Flucke on 08/15/00 at 3:22 AM:

Except for vias and pads for your components, make top and bottom layers solid copper and have a copper band around the perimeter of all the other layers.

Stitch all the layers at the board edge together with vias at the appropriate spacing for your clock edge speed.

Terminate the shield to earth or chassis. All connectors with high speed signals should have shields connected to this shield as well


Follow Ups:

Post a Follow-up:


Message to Post:


1999-2001 Sunlit Technology Co., Ltd. All rights reserved.