| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Plastic and Composite Components Forum > Message
Main Menu
Find

[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: High load high temp low friction

Date: 02/03/02 at 4:20 PM
Posted by: Carl Howarth
E-mail: howarthc@mediaone.net
Message Posted:

In Reply to: High load high temp low friction posted by John Schippers on 02/02/02 at 1:47 PM:

Well, this is a tough one.....


Metals work nicely at that temp! (kidding).

Most thermoplastics, including PEEK, PEK, PAEK, and Stanyl 4/6 nylon are gone by that temp. You might try looking into the thermosets like Torlon and Vespel. They are both expensive, and have proprietary processing (so you buy parts, not material).

Try looking at www.matweb.com for basic properties and to identify suppliers.

Good luck,
Carl


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.