[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Date: 10/09/03 at 4:06 AM
Posted by: rlmts
E-mail: rlmts@controlit.fsbusiness.co.uk

In Reply to: Re: Siemens System 8m Sprint. G Codes (G53) posted by Richard Lamb on 10/03/03 at 4:10 PM:

Hi everyone,
I've 'cracked it'!! :) (I think!)

Holding onto the fact that the sub-prog for toolchange had never been modified, I went down the avenue I mentioned in my last post.

I cleared and reloaded all software (after 'telling it' it was a System 8M) and the unit now responds to the G40 (as written at start of T/C routine L959)

Am I relieved!!

You all have a nice day!
Regards, Richard.

Follow Ups:

Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post: