[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Date: 03/06/01 at 2:51 AM
Posted by: khawja faisal
E-mail: khawjafaisal@yahoo.com

In Reply to: Forming tonnage required? posted by DLM INC on 11/18/00 at 12:06 AM:

take
Factor of safety as 1.5
find ultimate tensile strength
find the area of the bed as u needed
find out pressure ...the pressure can be find out by assuming an appropriate fluid that can be used for this kind of job.
use pressure=force/area
u will get the force then change it to ton.
good luck

Follow Ups:

Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post: