| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Forum of High Vacuum Technology/Processing/Coating > Message
Main Menu

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Power loss in sputtering

Date: 02/24/03 at 6:05 AM
Posted by: sarfaraz moh
E-mail: sarfarazmoh@yahoo.com
Message Posted:

In Reply to: Re: Power loss in sputtering posted by Pat McMahon on 02/11/03 at 9:13 PM:

Dear Pat the problem was that we were getting a low deposition rate as compared to the previous run.

As I was out of town I could not reply to your mail quickly.

Is this clear or do you need any specific infomation.

Sarfaraz Moh

Follow Ups:

Post a Follow-up:


Message to Post:


Click here:
1999-2001 Sunlit Technology Co., Ltd. All rights reserved.