| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Forum of High Vacuum Technology/Processing/Coating > Message
Main Menu

[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: E-Beam crucible liner for Nickle

Date: 11/21/02 at 2:14 PM
Posted by: jim moore
E-mail: jimtli@pacbell.net
Message Posted:

In Reply to: Re: E-Beam crucible liner for Nickle posted by tahir on 10/21/02 at 7:23 AM:

for Nickel use a Alumina oxide liner or a glassy coated carbon liner. Nickel is magnetic and when used in a Alumina Oxide liner (insulator) it will be somewhat difficult to start the source. Bring the power up slowly over a few minutes. The nickel will loss it magnetic propeties and the alumina will start conducting once you get some heat into it. At this point the source will stop arcing and you can increase power until you achieve the desired rate.

Follow Ups:

Post a Follow-up:


Message to Post:


Click here:
1999-2001 Sunlit Technology Co., Ltd. All rights reserved.