| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Forum of High Vacuum Technology/Processing/Coating > Message
Main Menu
Find

[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: sealing wire feed thru's with epoxy?

Date: 01/18/02 at 10:14 PM
Posted by: Pat McMahon
E-mail: film.vac@verizon.net
Message Posted:

In Reply to: sealing wire feed thru's wit epoxy? posted by Bill S on 01/16/02 at 2:06 PM:

Good Evening Bill,

It appears that you have found the source of your leak. You could use epoxy to make up a feedthrough if you wish but only use magnet wire and Hysol Epoxy. It is a messy project for sure.
If you have only a few wires, I could send you a couple of headers that have, I believe, seven or eight penetrations. These can be epoxied in with Hysol and make a reliable seal. They are about 3/8 inch in diameter.

Pat McMahon


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

Click here:
1999-2001 Sunlit Technology Co., Ltd. All rights reserved.