| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Forum of High Vacuum Technology/Processing/Coating > Message
Main Menu
Find

[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Leybold D60A Data

Date: 08/21/01 at 3:57 PM
Posted by: Jack Brown
E-mail: jackbrown@vactek.com
Message Posted:

In Reply to: Re: Leybold D60A Data posted by Sumit Jain on 08/20/01 at 5:58 AM:

You can resurface the plates and rebush them,
however you should not modify the cylinders or
pins, once this is done the pump will not pump down. The factory gives no clearance spec between the rotor and the cylinder. However they do on the following:

Bushing diameter-
front 22.033mm, center 22.070mm, rear 22.033mm

Shaft diameter-
21.991mm

Maximum inside diameter of cylinders-
118.535mm

Jack
http://vactek.com


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

Click here:
1999-2001 Sunlit Technology Co., Ltd. All rights reserved.