| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Forum of High Vacuum Technology/Processing/Coating > Message
Main Menu
Find

[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: chamber pumping

Date: 09/15/00 at 5:36 PM
Posted by: Frank Placido
E-mail: frank.placido@paisley.ac.uk
Message Posted:

In Reply to: chamber pumping posted by Rob Pierce on 09/13/00 at 11:32 AM:

Rob,

That's a hard one to answer for an unspecified system but here's one not so obvious place to look
- if you have a hi-vac valve operated by bottled gas or a compressor, check that the pressure is high enough to keep the valve closed during roughing. Quite often these valves don't seal properly unless the pressure is just right.

Frank


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

Click here:
1999-2001 Sunlit Technology Co., Ltd. All rights reserved.