[ List Subjects ][ Current Board ][ Post Message ]
Subject: Re: Need info on Parison programmer for blow moulding machine
[ View Followups ][ Post Followup ]
Date: 04/23/00 at 10:02 PM
Posted by: virut lay
In Reply to: Need info on Parison programmer for blow moulding machine posted by Rob Thomas on 01/22/00 at 12:45 AM:
: I'm looking for information on an Impulse Electronic Controls Parison Controller, model no PR2.
: This would be used on a plastic blow moulding
: machine. Even a contact within the industry that could point me in the right direction would be appreciated.
Post a Follow-up: