[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Date: 01/22/00 at 12:45 AM
Posted by: Rob Thomas
E-mail: thomo@dove.net.au

I'm looking for information on an Impulse Electronic Controls Parison Controller, model no PR2.
This would be used on a plastic blow moulding
machine. Even a contact within the industry that could point me in the right direction would be appreciated.

Follow Ups:

  Re: Need info on Parison programmer for blow moulding machine manoj n peshawe   Posted at: 01/11/01 (0)

  Re: Need info on Parison programmer for blow moulding machine siddique   Posted at: 10/11/00 (1)

  Re: Need info on Parison programmer for blow moulding machine firman   Posted at: 05/25/01 (0)

  Re: Need info on Parison programmer for blow moulding machine virut lay   Posted at: 04/23/00 (1)

  Re: Need info on Parison programmer for blow moulding machine siddique   Posted at: 10/11/00 (0)

Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post: