| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Technical Forum > Message
Main Menu
Find

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: fanuc o-t grapic conversational programing

Date: 04/24/02 at 2:18 PM
Posted by: Robert Plant
E-mail: rplant55@hotmail.com
Message Posted:

In Reply to: Re: fanuc o-t grapic conversational programing posted by Col on 10/18/00 at 5:07 PM:

the o-t fanuc control is basically a offspin of the fanuc 3-t. any fanuc manual will give you codes allowed on the o-t. moslty general FANUC coding. the only difference with the o-t is the fact o-t uses two line canned cycles format if that option is set in parameters.
ie. g71 u.1 r.01
g71 p10 q20 u.02 w.005 f.012

same with g76 two line format
ive been programing fanucs for 15 years now and used most controls on the market
if u have a specific problem feel free to emial me


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.