| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Technical Forum > Message
Main Menu
Find

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: maxnc mill

Date: 03/24/01 at 9:30 PM
Posted by: Greg Spahn
E-mail: gregs@rochelle.net
Message Posted:

In Reply to: maxnc mill posted by John Pimlott on 11/27/00 at 7:36 AM:

I have used my Maxnc Mill for about a year and a half, with no real problems. I did opt for the BSA screws and zero backlash nuts. The standard 1/4-20 screws took too much work to configure the backlash for and I cut may arcs and circles.
Over time, I have upped the amperage fed to the steppers, and now they seem to work better without skipping steps.
You can email any questions you have and I will try to assist. Thanks, Greg


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.