| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Technical Forum > Message
Main Menu

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: Denford Starturn CNC Software

Date: 05/10/03 at 8:22 AM
Posted by: A Barnett
E-mail: arthur@abarnett1934.freeserve.co.uk
Message Posted:

In Reply to: Re: Denford Starturn CNC Software posted by Hillis McMurray on 08/28/02 at 3:49 PM:

We have just purchased a Denford Starturn 8 Lathe.
There is no software or the dongle that fits into the serial interface.
I say there is no way that this can be run without the proper software and dongle.
My friend insists that it can be done using some other software.
I would be interested in your reply.
Best wishes,

Follow Ups:

Post a Follow-up:


Message to Post:


1999-2001 Sunlit Technology Co., Ltd. All rights reserved.